Bunny ears: an add-on for the top of the head
The Bunny ears add-on goes on the top of the head: two long rounded ears, leaning out. Needs head room: they are 34 mm tall. It adds 1.2 g of PETG and makes the bot 22 mm taller. On a bot built by 3D3D it adds $0.13, and it fits 8 of the 8 heads, the Gem head included.
- 1.2 gPETG added
- +$0.13on the built price
- 8 of 8heads it fits
- Earsgroup
How it is priced
It sits on the top of the head and makes the bot 22 mm taller. The price above is worked out on the Gem head on the Mini v2's body, from the same cost sheet as every bot: $0.11 a gram in PETG, 2 extra pieces, so it is a few cents, not a new part to buy.
Finishing: 2 kit pieces to glue on. 3D3D charges $25.00 an hour for that, counted by the minute when it slices the job, so it is not in the figure above.
Which heads it fits
| Head | Result |
|---|---|
| Gem head | Fits |
| Mini head | Fits |
| Dome head | Fits |
| Visor head | Fits |
| Cyclops head | Fits |
| Twin-lens head | Fits |
| Antenna head | Fits |
| Pod head | Fits |
Bodies it does not fit
- Tower body, Gem head: 126 x 110 x 208 mm: bigger than the 200 mm limit for a desk bot.
Not together with
- Twin antennas: The Antenna L 1 runs into the Bunny ear 1. (and 1 more)
- Crest: The Crest fin 1 runs into the Bunny ear 1. (and 3 more)
- Bear ears: The Bear ear 1 runs into the Bunny ear 1. (and 1 more)
- Cat ears: The Bunny ear 1 runs into the Cat ear 1. (and 1 more)
- Halo ring: The Bunny ear 1 runs into the Halo ring. (and 1 more)
- Carry handle: The Bunny ear 1 runs into the Handle. (and 1 more)
- Little horns: The Bunny ear 1 runs into the Horn 1. (and 1 more)
See every add-on or the questions people ask.
All prices are in Canadian dollars before tax and shipping. Bought parts are priced from amazon.ca listings (seen 2026-11-04), plus 15% when 3D3D buys them. Printing, the build and test fee and finishing are 3D3D's own rates, listed on the prices page.