Bear ears: an add-on for the top of the head
The Bear ears add-on goes on the top of the head: two round ears on the top corners. It adds 0.8 g of PETG and makes the bot 6 mm taller. On a bot built by 3D3D it adds $0.09, and it fits 8 of the 8 heads, the Gem head included.
- 0.8 gPETG added
- +$0.09on the built price
- 8 of 8heads it fits
- Earsgroup
How it is priced
It sits on the top of the head and makes the bot 6 mm taller. The price above is worked out on the Gem head on the Mini v2's body, from the same cost sheet as every bot: $0.11 a gram in PETG, 2 extra pieces, so it is a few cents, not a new part to buy.
Finishing: 2 kit pieces to glue on. 3D3D charges $25.00 an hour for that, counted by the minute when it slices the job, so it is not in the figure above.
Which heads it fits
| Head | Result |
|---|---|
| Gem head | Fits |
| Mini head | Fits |
| Dome head | Fits |
| Visor head | Fits |
| Cyclops head | Fits |
| Twin-lens head | Fits |
| Antenna head | Fits |
| Pod head | Fits |
Not together with
- Twin antennas: The Antenna L 1 runs into the Bear ear 1. (and 1 more)
- Crest: The Crest fin 1 runs into the Bear ear 1. (and 1 more)
- Bunny ears: The Bear ear 1 runs into the Bunny ear 1. (and 1 more)
- Cat ears: The Bear ear 1 runs into the Cat ear 1. (and 1 more)
- Halo ring: The Bear ear 1 runs into the Halo ring. (and 1 more)
- Carry handle: The Bear ear 1 runs into the Handle. (and 1 more)
- Little horns: The Bear ear 1 runs into the Horn 1. (and 1 more)
See every add-on or the questions people ask.
All prices are in Canadian dollars before tax and shipping. Bought parts are priced from amazon.ca listings (seen 2026-11-04), plus 15% when 3D3D buys them. Printing, the build and test fee and finishing are 3D3D's own rates, listed on the prices page.