Round vents: an add-on for the top of the head
The Round vents add-on goes on the top of the head: seven round holes in a flower pattern. It adds no plastic: it is cut into the head's shell. On a bot built by 3D3D it costs nothing extra, and it fits 4 of the 8 heads.
- No plasticit is cut into the shell
- $0.00on the built price
- 4 of 8heads it fits
- Vents and grillesgroup
How it is priced
It sits on the top of the head. The price above is worked out on the Mini head on the Mini v2's body, from the same cost sheet as every bot: $0.11 a gram in PETG, so it is a few cents, not a new part to buy.
Finishing: none. No piece needs supports taken off and nothing is glued on, so it costs $0.00.
Which heads it fits
| Head | Result |
|---|---|
| Gem head | Does not fit. Head shell: A wall is only 0.29 mm thick; the printer needs at least 1.2 mm. Make the wall thicker. |
| Mini head | Fits |
| Dome head | Does not fit. Head shell: A wall is only 0.29 mm thick; the printer needs at least 1.2 mm. Make the wall thicker. |
| Visor head | Does not fit. Head light seam: A wall is only 0.36 mm thick; the printer needs at least 1.2 mm. Make the wall thicker. |
| Cyclops head | Fits |
| Twin-lens head | Fits |
| Antenna head | Fits |
| Pod head | Does not fit. Head light seam: A wall is only 0.36 mm thick; the printer needs at least 1.2 mm. Make the wall thicker. |
Bodies it does not fit
- Crawler body, Gem head: Head shell: A wall is only 0.29 mm thick; the printer needs at least 1.2 mm. Make the wall thicker.
- Tower body, Gem head: Head shell: About 28 mm² of it hangs out too far to print without support. Try another print side, or add a seam so the inside opens up.
See every add-on or the questions people ask.
All prices are in Canadian dollars before tax and shipping. Bought parts are priced from amazon.ca listings (seen 2026-11-04), plus 15% when 3D3D buys them. Printing, the build and test fee and finishing are 3D3D's own rates, listed on the prices page.